YAMAHA MusicCAST2

Press and hold on the Music commander for two seconds or more. You can also use in the “Zone” screen when the Music Player is selected as a target zone. In addition, you can stop playback on all Music Players and turn off all zones of the network receivers at once by using the “All Stop” function.

You can switch display items page by page by tracing the right edge of the control pad up and down with your finger.

No, the MusicCAST2 products do not support video playback.

No, you cannot deliver those music contents via a network. You can playback those music contents only on the Music Player which the USB memory device or iPod is directly connected.

No, it does not.

You can play back Windows Media Digital Rights Management (WMDRM) protected content on the MusicCAST2 system if you use Windows Media Player 11 as a DLNA server. When using the TwonkyMedia server, you cannot play back the copyright-protected contents on the MusicCAST2 system. As for music files purchased from the iTunes Music Store, you can play back unprotected contents only.

The MusicCAST2 system does not support this feature. However, you may be able to browse some of those contents if you have configured the “Media Feeds” setting.

You can control up to 32 zones from the Music Commander. For a network receiver, each zone is counted individually (e.g. 3 zones for RX-V3900).

When a Music Player is connected to the network using a network cable, the wired connection is always prioritized. When the network cable is disconnected, a wireless connection between the Music Player and your access point (WiFi router) will be automatically established if the WiFi settings of the Music Player have been configured. In case the wireless connection cannot be automatically established, turn off and on the Music Player.

For the list of supported network receivers, please click on the following link.

Once you set the MAC filter setting on a Music Player, you cannot disable the MAC address filter function with usual operations. Carry out one of the following procedures to disable it.

No, they are not. Never use or install the products in moist conditions such as a bathroom.

No. Make sure you use the AC adapters supplied with the product.

Yes, an alarm will automatically turn off in 50 minutes even if you do not stop it.

You cannot adjust the volume level of alarm sounds individually. It will be turned up or down as you adjust the volume level of content playback.

The Music Commander can store about 70 learning codes (total number of key codes learned in “Remote Control” and “Amp Control”) at maximum. If it gets run out of space, you need to delete unnecessary learning codes. These functions are for MCX-P200 only.

It may be difficult because the emission of the supplied IR flashers is not enough for signal reading. Use a commercially available IR flasher that has the higher emission intensity or a pin cable to connect the Music Player (MCX-P200) and your remote control directly.