| Maximum output power | 200 W @ 4 ohms 0.1% (THD) at 1 kHz 120 W @ 8 ohms 0.1% (THD) at 1 kHz |
| Frequency response | +1, -1dB 20 Hz-20 kHz @ 1 W/8 ohms (Input Terminal: +4 dB) |
| Power Bandwidth | 10 Hz- 40 kHz @ 100 W/4 ohms 0.1% (THD) 10 Hz- 40 kHz @ 60 W/8 ohms 0.1% (THD) |
| Total Harmonic Distortion | Less than 0.07% 20 Hz -20 kHz @ 100 W/4 ohms Less than 0.05% 20 Hz-20 kHz @ 60 W/ 8 ohms |
| Intermodulation Distortion | Less than 0.07% 60 Hz: 7 kHz, 4:1 @ 100 W/4 ohms Less than 0.05% 60 Hz: 7 kHz, 4:1 @ 60 W/8 ohms |
| Residual Noise | -68 dB 20 Hz @ Input level control minimum -70 dB IHF-A network @ Input level control minimum |
| Signal to noise | 100 dB 20 Hz-20 kHz @ Input 600 ohms shunt 105 dB IHF-A network @ Input 600 ohms shunt |
| Slew Rate | +/-8 V/mm sec @ 8 ohms, Full swing |
| Maximum voltage gain | 27.2 dB @ +4 dB Input, 1 kHz 51.2 dB @ -20 dB Input, 1 kHz |
| Sensitivity | +4 dB 200 W/4 ohms @ +4 dB Input, 1 kHz -20 dB 200 W/4 ohms @ -20 dB Input, 1 kHz |
| Graphic equalization | +/-12 dB maximum boost or cut in each of seven bands. 125,250,500 Hz, 1 k, 2 k, 4 k, 8 kHz: peaking |
| Limiter | Input overload:15 dB |
| Input impedance | 10 kohms |
| Indicator LEDS | Power Red LED is lit when power is "On" Protection Red LED is lit when protection circuitry is activated. Limiter Red LED is lit when limiter circuitry is activated. |
| Protection circuit | Power on mute 6 +/-2 sec. Muting time DC sense DC +/-2 V Output shut off PC limiter less than 2 ohms @ Load impedance |
| Power Requirements | UL/ CSA model 120 V AC 60 Hz General model 220/240 V AC 50/60 Hz |
| Power Consumption | UL/CSA model 180 W General model 180 W |
| Dimensions ( W x H x D)
| 480 x 88 x 370.5 mm (18-7/8" x 3-7/16" x 14-9/16") |
| Weight | 9.5 kg (20 lbs 15 oz) |
