How to configure key codes by following on-screen instructions
How to configure key codes by following on-screen instructions
blank
blank
blank
The Music Commander can store about 70 learning codes (including key codes learned in “Remote Control”). If it gets run out of space, you need to delete unnecessary learning codes.
blank
blank
1
Music Commander:[Easy Setup]
blank
blank
blank
2
(to proceed)
blank
blank
blank
blank
3
Perform the following operations sequentially.
blank
(to set the target Music Player into the learning mode)
If countdown starts in the Music Commander's display, aim the remote control directly at the LAN LED of the Music Player and then hold down the remote control key from which the code is learned.
Release the remote control key if “Leaning Completed” appears in the Music Commander's display.
blank
blank
To skip to the next key (without learning from the current key):
blank
blank
blank
blank
If “Learning failed” appears, select “Retry” to retry the operation from step 3 or “Cancel” to cancel the operation.
If you press the remote control key before countdown starts, learning may fail even if “Learning Completed” appears.
blank
blank
blank
4
Repeat steps 3 until all the key codes are learned.
blank
blank
blank
5
(to confirm the setting)
blank
blank
blank
6
(to change the “Audio Output” setting) or (not to change)
blank
blank
Before you change the “Audio Output” setting to “Fixed”, be sure to turn down your amplifier volume.
blank
blank
blank
blank
